RELATED QUESTIONS

• 
  I have a 1993 Ford Explorer 4 x 4 and when I try to push the button for 4 wheel drive nothing happens, the amber light next to it doesn't light up and neither doe the 4 x 4 light on the dashboard and I can't tell if its just the lights or the 4x4 drive
• 
  What is wrong with a 94 ford explorer 4x4 v6 that cranks and wont start. ICM is good, no oil on plugs,(brand new) ig coils test fine, has compression, fuel pump works, brand new starter.
• 
  What does my 1998 ford explorer sport 4x4 weigh?
• 
  Where is the CAM Shaft Sensor and sychronizer on a 1999 Ford Explorer Sport? What do they look like? I know they are in the intake manifold, but I do not know what they look like. Do I need any special tools to change them or to resyn
• 
  What year manual transmissions are interchangeable with the 87 ford ranger 4x4 2.9 V6. when did they change
• 
  The orange "overdrive off" warning light began to flash on the dash of my '97 Explorer recently, and about the same time, as I ease off accelerating it will frequently change down a gear. The auto fluid level is fine, any suggestions as to the cause?
• 
  The brake light keeps coming on, on the dash board of my 1997 Ford Explorer. At first it would blink on, now it stays on a little longer, and on and off some times. Should I check the brake fluid level and sensor? Or the parking brake switch?
• 
  The speedometer on my 1994 f150 4x4 has stopped working, and when it did the transmission started shifting rough. Have checked all the fuses and they're all good. What do you think is wrong and where do I look?
• 
  My 1994 Ford Ranger is stuck in 4x4 low gear. the lights do not turn on on the button panel where i change them and i have tried everything from turning the hubs to free to turning the car off and pushing the buttons to checking the fuses and still nothin
• 
  I have a 1999 ford Explorer 2WD. The ABS light came on last week and does not go out, brake fluid level is ok. I am told that it may be a wheel sensor that needs to be replaced. How do I know which one is causing the problem and needs to be replaced?