- NEW!
by brp on July 4th, 2009
in the front of the truck up inside the bumper or grill there are 2 small metal cubes they are filled with a kind of rubber plainly visable on one side with the airbag sensor inside it. going to the cubes should be 2 wires each you should be able to just cut the wires and it should be fine,there also might be the same kind of cube on the drivers side of the truck under it attached to the frame also cut the wires on that one and check passenger side also
by Borderlinux on February 9th, 2009
Drive it drunk.
by Dodgy Dog in a Sable COAT on July 12th, 2009
Drive it into a pole.
by Samgie on July 12th, 2009
Did you check the brakes.
by straight-shooter on November 20th, 2009
Bad ideas, funny though, Try this: Disconnect the negative battery cable, Unplug the SIR fuse(s) then, under the dash , unplug the bright yellow airbag wiring connector(s)
what engines will fit in a 1988 isuzu trooper 4x4. it has a 2.6 liter engine in it
by Eric_O on February 3rd, 2011
| 1 person likes this
My 96' Ford Ranger, 4.0 is idling badly. Smells like gas as well. Changed one of the o2 sensors, coolant temp sensor as well.
by astamp87 on March 9th, 2011
| 1 person likes this
2001 ford exploer limited door ajar light go on and off any thou doors are closed
by Kenner15 on April 25th, 2011
| 1 person likes this
2004 lincoln aviator...seems to skip and slightly buck when under a constant load going uphill...any tthoughts
by Rrocco on May 14th, 2011
| 1 person likes this
The brake lights on my 1994 Chevy 3500 stay on, how do I change the brake pedal switch?
by hiddenjewelfarm on May 17th, 2011
| 1 person likes this
You're reading How to deploy airbags in 1997 ckev truck so kid can use it for wood truck
Your favorite Q&A site is on Facebook! Become a fan to connect with the ever-growing community of Answerbaggers, share your thoughts and find out what Answerbag's up to next!
Comments