My motor stumbles when trying to move, in neutral it is fine revs good, but in gear it sluggish.motor is new, lunati cam, 458lift 1.6 roller rockers edelbrock heads carter carb(rebuilt) tranny is good
by 
caperkev
ANSWERS: 3
-
timing was dropped to 0 degrees on crank, new plugs gapped at what edelbrock says to gap them at for the heads, flat top piston, 30 over, 120 lbs compression acrooss the board, heads are 66 cc i think
-
is almost like the car is mis firing when trying to move, any ideas, as i have spark at all plugs, plugs were changed twice,distributor is brand new accel coil is accel super coil, wires are med 8.8s
-
just use the adjuster screw on the carb or whatever fuel body u have to increase the idle so bump the idler screw up a little bit please rate this answer and with that cam its supposed to do that that cam gives you high end power not low end the higher the lift the more sluggish sound please rate my answer
RELATED QUESTIONS
Copyright 2023, Wired Ivy, LLC