- NEW!
by Junk Yard Dog on January 31st, 2007
Check the distributor cap/rotor, if you have one, or maybe it's a crankshaft/camshaft positon sensor. Could be that the distributor has jumped time as well, and needs to be properly reinstalled. Dosn't hurt to buy new spark plugs, and check proper gapping either....
by tagasaysdontworrybehappy on February 17th, 2008
change the distributor
by john pennington on February 17th, 2008
But, have you changed the timing belt?
How many miles on your vehicle?
by jazzcornet on February 17th, 2008
ohm out your distributor and see if its good. this is very common for our cars. you could replace the entire egnition system and nothing will change. the pickups in your distributor are very sensitive and are probably toast.
by Guychef on January 31st, 2007
I'm not familiar with your model. I had a similar problem with an older Mazda, it turned out to be a faulty ignition switch.
Good luck.
Which Mazda Rx-8's came with paddle shifters?
by yank4lif3 on August 1st, 2010
| 1 person likes this
2001 mazda b2500 2wd, torque on rear pinion nut after overhaul w/ new crush collar?
by bwaters78 on July 16th, 2010
| 1 person likes this
2007 mazda 3 when i start the car, sit idle or even drive it makes a humming noise that comes from the rear of the car, any idea what it is?
by daviddobos on July 6th, 2010
| 1 person likes this
how much will a mechanic charge to replace a crank sensor on a mazda protege 2000
by swasid on August 19th, 2010
| 1 person likes this
COMPUTER DIAGNOSIS SHOWS A PROBLEM WITH THE KNOCK SENSOR OF MY mAZDA 323 PROTEGE MODEL 2003, WHERE IS IT LOCATED?
by Bathusi_R on December 9th, 2011
| 1 person likes this
You're reading Ive got a 92 mazda protege when ur driving it stalls from loss of spark ive changed the coil both igniters and there is still no spark?
Your favorite Q&A site is on Facebook! Become a fan to connect with the ever-growing community of Answerbaggers, share your thoughts and find out what Answerbag's up to next!
Comments