ANSWERS: 3
  • Unless you are running a LOT of Power, it should work OK.
  • I agree with ET-11, but if you really want to be a perfectionist, you could put a high-power 2 Ohm resistor in series with the speaker. Most amplifiers are designed to deal with 4-8 Ohm speaker loads, though.
  • will not give any problem at all, if you are running more than 200-300 watts might want to match loads a little better but you would not be running 6 ohms then

Copyright 2023, Wired Ivy, LLC

Answerbag | Terms of Service | Privacy Policy