- NEW!
by WaterMaster on July 20th, 2008
Check the oil pressure fuse. It is the same one that runs your engine computer. If it is blown, check to see if the sending wire going to the oil pressure sending unit on your engine is grounded out. That is what happened to me and they charged me way too much to find that out. It is a simple fix, less than a buck....or it could cost you way over 100.
My car has been Jerking really bad when I drive, like ill go 20 mph's and it will jerk I have to ease into speed, why does it do that?
by sarahevans07 on May 3rd, 2011
| 1 person likes this
i have a 99 chevrolet suburban, i can crank it but it wont stay on. whats theproblem
by Brandee_L9432 on September 3rd, 2011
| 1 person likes this
My buddy has a 94 buick sadan wth a 3.8 It has no spark,,, any ideas??
by Robert_B8777 on August 8th, 2011
| 1 person likes this
'97 350 new crank,rod,main bearings,timing,gears,plugs,wires now has a runs good but has a burp like as misfire but not all the time.HELP
by weld on August 10th, 2011
| 1 person likes this
where do i add power steering fluid in my 2004 chevy malibu
by chevytruck39 on June 29th, 2011
| 1 person likes this
You're reading No fire on a 1988 s-10 2.8 new plugs,wires coil ,cap and rotor, what would cause this? It was running then just quit.
Your favorite Q&A site is on Facebook! Become a fan to connect with the ever-growing community of Answerbaggers, share your thoughts and find out what Answerbag's up to next!
Comments