- NEW!
Help answer this question below.
Some times there is a small pin that holds the key cylinder in but if you are replacing the entire switch then there should be 2 little screw type bolts or 4 some times holding it onto the colum.
use pliers on it and turn counterclock wise until u fill it loosen and pull it out
go to your local parts house,most will let you rent tool to compress stering wheel,its almost impossible to take the stering wheel off without it,and if you do get it off without the tool you wont get it back on.that is the hardest part of the job.after you get stering wheel of the rest is easy.
I need to know how to tune a rochester carb qudrajet it is a 4bbl it is for my 1975 chevy pickup or how many turns on the carb to get the right settings i talking about the fuel mixture. the motor is a 350 and automatic transmission th350
by harrison on June 13th, 2008
| 1 person likes this
I NEED TO KNOW IF ANY BODY CAN TELL ME HOW TO REMOVE KEY SWITCH FROM A 1974 CHEVY PICKUP COLUMN I HAVE PUSHED SHOVED PUT SCREWDRIVERS IN SLOTS NO LUCK HELP LOST WITH OUT MY TRUCK
by hanky on March 31st, 2008
| 1 person likes this
What trailer brake controller should i use on a 68 chevy 3/4 ton
by cheese on January 20th, 2008
| 1 person likes this
I have a 1966 Chevrolet pickup with a three speed shifter on the column. I would like to change it to three speed on the floor. Do I have to change the entire transmission or can I just change the linkage setup?
by ardsee on January 19th, 2008
| 1 person likes this
I have a 1966 Chevrolet pickup truck, with a speed on the column . I would like to change to a three speed on the floor. Does the entire transmission have to be changed or just a change of the linkage setup to put in a floor shifter?
by ardsee on January 19th, 2008
| 1 person likes this
You're reading I NEED TO KNOW IF ANY BODY CAN TELL ME HOW TO REMOVE KEY SWITCH FROM A 1974 CHEVY PICKUP COLUMN I HAVE PUSHED SHOVED PUT SCREWDRIVERS IN SLOTS NO LUCK HELP LOST WITH OUT MY TRUCK
Comments