- NEW!
by csimme01 and Ninja Cooper UNMASKED on December 30th, 2007
Your best bet would to get another connector with as much wire as possible from a scrap yard and splice the new connector onto the existing wires. Twist solder and shrink tube all connections. You wouldn't want to use any kind of crimp on connectors or splices because they will fail quickly with the amount of current in that circuit.
Where is the transfer case relay in a 1999 Ford Ranger?
by Answerbag Staff on August 17th, 2010
| 1 person likes this
Where is the speedometer sensor on a 1998 Ford Ranger?
by Answerbag Staff on August 17th, 2010
| 1 person likes this
Where is the fuel pump on a 1987 Ford Ranger?
by Answerbag Staff on August 6th, 2010
| 1 person likes this
So I'm trying to decide on a new truck for me....95 ford bronco with a full body lift kit? Or a 99 ford ranger lifted pre runner style?
by ColeyBabii8573 on May 4th, 2011
| 1 person likes this
95 ford ranger 2.3l No start has fuel air just no spark. need part and location of where the problem is thanks!
by krystle.r.niedermeyer on April 24th, 2011
| 1 person likes this
You're reading I have a 2000 Ford Ranger 3.0L V6. The blower motor resistor connector has melted to the blower motor resistor. I was wondering how hard it is to rewire the connector and what that entails.
Your favorite Q&A site is on Facebook! Become a fan to connect with the ever-growing community of Answerbaggers, share your thoughts and find out what Answerbag's up to next!
Comments