I have a miller trailblazer welder, it is set up for stick, tig and mig the problem is in stick mode when the welder is in low idle you can strike an arc but as soon as high run kicks in the arc goes completely dead and will not come back until it idles

More Questions. Additional questions in this category.

• 

  What does a level 1 welding inspector earn in Alberta?
  by Answerbag Staff on August 8th, 2010 | 1 person likes this

• 

  What is the average salary of a welding engineer?
  by Answerbag Staff on May 7th, 2010 | 1 person likes this

• 

  About how much do aluminum welders make an hour?
  by Answerbag Staff on May 6th, 2010 | 1 person likes this

• 

  How to start a welding career
  by jacobgentry on December 8th, 2010 | 1 person likes this

• 

  for aluminume welding we must use special mig welder machine or any mig welder with or without changing the wire feed liner to teflone?
  by salalmt on June 15th, 2011 | 1 person likes this

• More Welders See only professionally researched Welders questions