by 
hrudinski
ANSWERS: 1
-
Put the gear shift down in first. Pull off the plastic cover over radio and a/c controls. It is just snapped on tightly. Once it is out of the way you will see little screws holding the switch controls in. Just remove the screws, uplug the wires on the back, and remove the switch. If the blower motor is not operating or is operating on only one or two speed levels, more than likely it is a blower motor resistor problem. It is located behind the glove box in the vent duct (4 wire harness). Before replacing anything I would check fuses #7 10amp, #8 20amp, and #10 10amp in the engine compartment.
RELATED QUESTIONS
Copyright 2023, Wired Ivy, LLC