- NEW!
by allikatzpop on November 22nd, 2009
ddec code 43 coolant level low.check the coolant level sensor by unplugging and jumping the plug w/ a paper clip.
by firehorse on November 21st, 2009
There is 2 fuel lines in back of the engine coming out of the head,The one on the right side is your return line,in that line there is a inline check valve,you need to replace it. It cost about 95 dollars.
t
by David_H2489 on January 16th, 2012
you have a check valve in back of head and it can get gummed up over time. change thew check valve so you won't be loosing prime after sitting for a while
by DoubleR on December 17th, 2011
It sounds like you are loosing your prime on your fuel. I would check all lines for leakage and all fittings for cracks or looseness. Hope this helps.
I use a website that has dancing girls in blue jeans atop tractor trailer rigs. But no forum. Why no forum?
by einsteinwasright0116 on May 18th, 2011
| 1 person likes this
how do i turn off the heater for good in a 1999 mack truck ch600
by Rhiann_C on June 27th, 2011
| 1 person likes this
1997 freightliner wheel spin light comes on the dash it bothers me how can fix it
by truckerboy on February 21st, 2011
| 1 person likes this
In the U.S., why do bus drivers and truck drivers have different rules for hours of driving and service when they used to be the same?
by ccrunch171 on April 30th, 2011
| 1 person likes this
Why does a semi-truck need to be started and run often?
by onenormlguy on May 31st, 2011
| 1 person likes this
You're reading I have a 1999 freightliner detroit diesel 60 series 12.7L, sometimes when I shut the truck down and let it sit for a few minutes and try to start it, it will not start. but it will start with starting fluid, or it will start by a push start. codes 42,43
Your favorite Q&A site is on Facebook! Become a fan to connect with the ever-growing community of Answerbaggers, share your thoughts and find out what Answerbag's up to next!
Comments