- NEW!
Help answer this question below.
Do i need to remove the axle to replace the rear wheel studs on my f 250 xlt
by bri62506 on April 4th, 2009
| 1 person likes this
I have a 97 f250 7.3L, cranks and runs fine for 3 seconds then check engine light comes on and starts sputtering like only running on half of the cylinders, OBD 2 registers no codes. Any ideas?
by Anonymous on February 8th, 2009
| 1 person likes this
I have a 1997 f 250 powerstroke 7.3.. can any 1 tell me the power steering pump if it has 1 inlet or 2?
by noochie31 on February 6th, 2009
| 1 person likes this
Where can i find a ford f-250 rim with 8 holes? the wheels are 16 x 7.50, 12-ply.
by oxymoron on February 26th, 2009
| 1 person likes this
* Continued * Then Some Times During This It Will Reverse And Act Like It Has No Horse Power , Even Act Like It Is Ruining Out Of Gas ,Then With A Chock And Sudden Jerk It Will All Stop And The Light Will Go Off And Every Thing Will Be Normal
by keating on May 24th, 2009
| 1 person likes this
You're reading Where is the inertia switch located on my 1995 ford f250 7.3 diesel 4x4.