1) Disconnect negative battery cable and remove battery. Wait at least 90 seconds before starting work to prevent air bag deployment. Disconnect throttle cable. Remove cruise control actuator (if equipped). Disconnect airflow meter connector and remove air cleaner assembly. Remove ground strap. 2) Remove engine upper left mounting bolt. Remove starter. Disconnect vehicle speed sensor, park/neutral position switch and both solenoid connectors. Remove 3 transaxle mounting bolts. Disconnect transaxle fluid cooling hoses. Install engine support and raise vehicle. Remove engine undercovers and drain transaxle fluid. 3) Remove front wheels. Remove drive axle lock nut. Disconnect stabilizer bar links from lower arms. Disconnect tie rod ends and ball joints from steering knuckle. Remove left side drive shaft. Remove 2 center bearing bracket bolts and remove right side drive shaft and center bearing case. 4) Support transaxle with jack. Disconnect shift control cable. Remove rear engine mounting bolt. Remove front exhaust pipe. Disconnect intermediate steering shaft at rack. Disconnect power steering lines at rack. Remove 2 shift cable mounting bolts. Disconnect air conditioner line bracket.