ANSWERS: 2
  • IAT sensors are located in the Mass Air Flow sensor. And also it is a 4.8 liter motor, 4.6 is a Ford displacement.
  • 1. Disconnect battery terminals and remove battery and battery box. 2. Disconnect mass air sensor and waste gate solenoid valve wiring connectors. Remove vacuum hose pointing towards back of car off waste gate solenoid valve (this hose leads to turbo wastegate). Remove air canister/mass air sensor and intake tube that runs from sensor to turbo inlet. 3. Remove cotter pins on both the shift cable and select cable. There is a washer on either side of each cable connection (4 total). Remove 2 bolts from shift cable bracket on top of transaxle. Move cables toward back of engine compartment and out of the way. 4. Remove (2 bolts) clutch release cylinder hydraulic line bracket on top of transaxle. 5. Remove speedometer cable and reverse light switch connector off transaxle. 6. Remove transaxle bolts that can easily be accessed from engine compartment. Remove starter bolts. Move starter away from flywheel. NOTE The starter wires do not have to be disconnected NOTE The cruise control cables or ABS hydraulic unit are located between the battery and airbox. They should not have to be removed. 7. Loosen front wheel lugs. 8. Raise the entire vehicle high enough to allow transaxle to be lowered onto a floor jack and pulled from under the car while still on the floor jack.

Copyright 2023, Wired Ivy, LLC

Answerbag | Terms of Service | Privacy Policy