- NEW!
by einstein-a-go-go on June 7th, 2008
Well...the filter is located on the inside of the frame under the driver's door.
The fuel filter is located underneath the truck on the drivers side frame rail. You will need to raise the truck safely to get under. You will need a 21mm and a 16mm wrench. The 16mm wrench should be a line wrench so you don't ruin the hex head of the fitting.
While holding the 21mm wrench on the fuel filter fitting, turn the 16mm wrench counter clockwise to break loose the fitting nut on both sides of the filter. Then you need to pull the line out of the filter and let the fuel pressure drain off.
NOTE: If you let this thing sit overnight and do it first thing BEFORE you start it, there should be very low pressure in the lines. If you do it after it's been running you will be getting a bath of gas on you!! BE CAREFUL!
The filter needs to be removed from the black plastic bracket. It should slide right out. Good Luck!
Does the GM 3.6L engine use a timing chain in the GMC Acadia?
by Answerbag Staff on August 22nd, 2010
| 1 person likes this
Where is the temperature sensor on a 1996 GMC Jimmy located?
by Answerbag Staff on August 16th, 2010
| 1 person likes this
Where is the temperature sensor on a gmc 4.3?
by Answerbag Staff on August 16th, 2010
| 1 person likes this
waht are the most restrictive parts from the air intake to the muffler in a stock GMC sierra 2WD 1500? please explain reasoning. thanks :)
by gilbo on July 12th, 2011
| 1 person likes this
few of us were wondering if the late 80's 350 gmc jimmy does actually have gear driven timing or a belt/chain?
by 5150.featherwood on May 10th, 2011
| 1 person likes this
You're reading How do you replace fuel filter on 1999 gmc jimmy
Your favorite Q&A site is on Facebook! Become a fan to connect with the ever-growing community of Answerbaggers, share your thoughts and find out what Answerbag's up to next!
Comments