- NEW!
by bigboo on January 14th, 2008
if it is like a clicking noise in the center of your dash you need to change the blender motor. That motor changes your heat from defrost to heat and the gears strip and they make that noise, about 75.00 from dealer on a scale from 1 to 10 this job is about an 8 so if your not too handy bring it to a garage.
Where are o2 sensors located on 2000 ford windstar?
by Answerbag Staff on August 18th, 2010
| 1 person likes this
Where is the camshaft position sensor located on a 1995 Ford Windstar?
by Answerbag Staff on August 16th, 2010
| 1 person likes this
Where is the PCV valve on a 2002 Windstar?
by Answerbag Staff on August 5th, 2010
| 1 person likes this
I have a 2002 Ford windstar that gets no heat. Already changed the actuator but still no heat. Door moves smoothly in both directions. ???
by ronbarrii on December 1st, 2010
| 1 person likes this
98 Windstar stalled and now willnot start turns over cannot ssmell gas and do not see spark when removing 1 ignition wire
by MGG on August 27th, 2010
| 1 person likes this
You're reading I have a 2000 Ford windstar, there is a "knocking noise" in the center of the dashboard and I have no heat. When you turn the heat off and change to climate control to cold the knocking noise stops. What could be wrong?
Your favorite Q&A site is on Facebook! Become a fan to connect with the ever-growing community of Answerbaggers, share your thoughts and find out what Answerbag's up to next!
Comments