- NEW!
by G. WASH. on March 17th, 2009
FROM A MECH.: 1st: block 'opposed wheels'; 2d: loosen (but do not remove) all nuts on "the flat". If flat is on front: Behind wheel, along chassis, place jack saddle on a strong, firm, flat surface, & jack up; If on rear: In front of wheel, along chassis, etc.. STRONGLY RECOMMENDED: as you are apparently 'a novice', have someone who is familiar with this procedure on site.
by xcspirit85 on March 17th, 2009
under frame. block wheels
What is the location of the throttle position sensor on a 1995 Ford Taurus?
by Answerbag Staff on August 17th, 2010
| 1 person likes this
Where is the catalyst temp sensor on a Ford Taurus?
by Answerbag Staff on August 17th, 2010
| 1 person likes this
Where is the OBD connector on the 1993 Ford Taurus?
by Answerbag Staff on August 5th, 2010
| 1 person likes this
Do you like the new Ford Taurus sleek design?
by socialist22 on April 14th, 2011
| 1 person likes this
My '03 Taurus speedometer moves when stopped, will jerk and have instrument panel light up and might cut off while in gear. Suggestions?
by brmcclelland on April 2nd, 2011
| 1 person likes this
You're reading Change tire.. ford taurus 1994.Lost my owners manual..where do I place the jack under the car..? can't seem to find anything that lines up with the jack..baffled..
Your favorite Q&A site is on Facebook! Become a fan to connect with the ever-growing community of Answerbaggers, share your thoughts and find out what Answerbag's up to next!
Comments