How to Make a Rabbit Snare

by Curtis Fease

Instructions

Step 1:
Cut off a piece of stainless steal wire measuring about 21 inches long.
Step 2:
Bend the wire into a small loop about 1.5 inch from one end of your wire. Twist the wire until the loop is formed and tight enough not to come loose. If the loops comes loose, the rabbit can escape.
Step 3:
Bring the other end of the wire through the small loop you made at the other end. This will form the larger loop that will capture the rabbit around the neck.
Step 4:
Form another small loop on the end of the wire you just brought through the first loop. Follow the same instructions as making the first loop, bending the wire about 1.5 inch from the end of the wire. Once again, tighten the new loop so it won't come loose.
Step 5:
Cut off enough string to suit your snare purposes. The length will depend on how you are going to set up your snare. Cut off a few extra inches to ensure the string is long enough to set your snare. Tie one end of the string to the second loop you formed. Get ready to snare some rabbits.

There are numerous ways to set up your snare once you have built it. Click "Setup" below to see how to set up your snare.
This snare isn't intended to catch pet rabbits. Wild rabbits can be dangerous, so don't let their size fool you. Also, this snare can strangle the rabbit, hindering its ability to function as a pet.

www.prosnares.com