Pre-1980 trucks and SUVs.

How do i fix my fluctuating idle on my 80 chevy.
by Anonymous on June 26th, 2009 | one answer | in Pre-1980 trucks and SUVs

by Anonymous on December 31st, 1969 | no answers | in

My 80 chevy scottsdale has a problem with fluctuating idle, i have changed the distributor cap, plugs, and wires. it gos from 700 idle to 500 and up to 1000 then back to normal idle, ne one know how to fix this.
by Anonymous on June 26th, 2009 | 2 answers | in Pre-1980 trucks and SUVs

Installing turn signal switch lever cam w/o tilt, including the cancel springs on a 1970 C10 pick up
by Wolf on June 3rd, 2009 | one answer | in Pre-1980 trucks and SUVs

What do i need to do to break in my new engine? when do i change the oil? what mileage is it broke in? it has 500 miles on it right now. its a chevy 350
by devencollins on April 22nd, 2009 | one answer | in Pre-1980 trucks and SUVs

1983 chevy c10 305 v8 wont start- new plugs, timing chain, battery, (distributor ok new module and condensor) even ran hot wire to dist. still wont start
by pitbull on March 30th, 2009 | no answers | in Pre-1980 trucks and SUVs

What is firirng order for 1980 chevy luv?
by walter on January 28th, 2009 | one answer | in Pre-1980 trucks and SUVs

What years 454 will fit in a 1967 el camino without an modification to the hood or oil pan?
by el camino on December 11th, 2008 | one answer | in Pre-1980 trucks and SUVs

My 1979 C10 has had the electric fuel transfer valve permanently bypassed. This valve appears to have two solenoids with a total of 4 nipples on the backside (not shown). How do I install the correct setup. picture at www.neatinfo.com/public/temp
by Anonymous on December 1st, 2008 | no answers | in Pre-1980 trucks and SUVs

Mr.bill i have reaplaced all plugs and wires and cap and roater so still it sounds like it some one else told the timing to would that cause it not go over 35
by Anonymous on December 1st, 2008 | one answer | in Pre-1980 trucks and SUVs

Well i just bought a 1980 chev c-10 4.1 and i dont know much about and i need to know the firing order because it sounds like its miss firing but its really close and wont go over 35 could it be something else thats causing it too sound this way
by Anonymous on December 1st, 2008 | one answer | in Pre-1980 trucks and SUVs

What is the sequence on a 1951 chevy truck, manual transmission
by joejoe on July 29th, 2008 | one answer | in Pre-1980 trucks and SUVs

I have a 79 chevy pickup with a 355 chevy small block. Recently for some reason won't start, not even a click. New battery, alternator ok, starter ok, hot wire and ground wire ok. fusible links ok. neutral park switch ok. Any suggestions?
by ratfink on July 7th, 2008 | 2 answers | in Pre-1980 trucks and SUVs

I need to know how to tune a rochester carb qudrajet it is a 4bbl it is for my 1975 chevy pickup or how many turns on the carb to get the right settings i talking about the fuel mixture. the motor is a 350 and automatic transmission th350
by harrison on June 13th, 2008 | one answer | in Pre-1980 trucks and SUVs

I NEED TO KNOW IF ANY BODY CAN TELL ME HOW TO REMOVE KEY SWITCH FROM A 1974 CHEVY PICKUP COLUMN I HAVE PUSHED SHOVED PUT SCREWDRIVERS IN SLOTS NO LUCK HELP LOST WITH OUT MY TRUCK
by hanky on March 31st, 2008 | 3 answers | in Pre-1980 trucks and SUVs

I am looking where I can find the fuse panel diagram in a 1979 Chevy k-10 pickup. I am having problems getting the heather fan working.
by platinum1 on March 12th, 2008 | 4 answers | in Pre-1980 trucks and SUVs

I can not get my 1972 chevy truck to start. It gets fuel, turns over, but will not start. I checked all electrical wires and they are still connected. I drove it recently (about two weeks ago) and parked it without any problems. Anyone have any ideas?
by 72cheyenne on February 15th, 2008 | 3 answers | in Pre-1980 trucks and SUVs

What trailer brake controller should i use on a 68 chevy 3/4 ton
by cheese on January 20th, 2008 | one answer | in Pre-1980 trucks and SUVs

I have a 1966 Chevrolet pickup with a three speed shifter on the column. I would like to change it to three speed on the floor. Do I have to change the entire transmission or can I just change the linkage setup?
by ardsee on January 19th, 2008 | 2 answers | in Pre-1980 trucks and SUVs

I have a 1966 Chevrolet pickup truck, with a speed on the column . I would like to change to a three speed on the floor. Does the entire transmission have to be changed or just a change of the linkage setup to put in a floor shifter?
by ardsee on January 19th, 2008 | 2 answers | in Pre-1980 trucks and SUVs

Will a engine from a 1991 chevy 5.7 liter engine fit into a 1971 chevy c 10 2wd pick up?
by 71chevyc10 on January 17th, 2008 | 2 answers | in Pre-1980 trucks and SUVs

Are 68-72 chevy two wheel drive and four wheel drive frames the same
by cheese on January 11th, 2008 | 2 answers | in Pre-1980 trucks and SUVs

1979 chevy, C 60 Need to ID rear end. No tag on it .13 bolts on rear cover and same on front housing.Single speed.36 teeth on ring gear, 5 on pinion.Has budd type hubs.16000 weight. any help appricated
by chillywillie58 on December 10th, 2007 | no answers | in Pre-1980 trucks and SUVs

I have a 1949 Chevy 3600 Pick-up with a straight six overhead valve engine, and the only numbers I can find on the engine are on the passenger side behind the distributer just like this B44 848 850 any one know what engine this is?
by viashino on December 3rd, 2007 | 2 answers | in Pre-1980 trucks and SUVs

I am replacing a heater core in a 76' c-10 with AC, where are all the mounting bolts for the air box? I found one on the right side, the rest have a "round" head on them, If these are the mounting screws how can i get them out?
by Jesus freak on December 1st, 2007 | one answer | in Pre-1980 trucks and SUVs

I want to replace the gear shift handle on my 1975 Chevy c10 pick-up w/auto trans. When I remove the handle, will any parts drop down inside of the steering column or will they stay in place until I insert the new handle?
by Anonymous on October 25th, 2007 | one answer | in Pre-1980 trucks and SUVs

Where is the oil pump in a 1975 Chevy Scottsdale V8?
by thomas on August 17th, 2007 | one answer | in Pre-1980 trucks and SUVs

I'm a complete novice - how can I tell which fuse is out if my blinkers aren't working on my '77 Custome Deluxe 20? Is it easy to replace myself or should I take it in to have it done?
by Anonymous on August 16th, 2007 | one answer | in Pre-1980 trucks and SUVs

Where is the electric fuel pump relay located on my 1978 chevy LUV truck. I am only getting about .5 volts at the pump, and that is not enough for the pump to run.
by wwincorp on August 4th, 2007 | one answer | in Pre-1980 trucks and SUVs

Where do i get a diagram to install the fuel pump on a 1979 chevy custom deluxe 30, with a 305 engine?
by bub on July 18th, 2007 | one answer | in Pre-1980 trucks and SUVs

I have a 5 spd tranny out of a 1990 chevy truck that i would like to use in my 1980 truck that has a 4spd with 456 gears i think this truck would run good with a 5spd how would i go about this project or is it worth it only getting 9 miles per gallon
by Anonymous on July 12th, 2007 | 3 answers | in Pre-1980 trucks and SUVs

454 Chevrolet 7.4 liter engine from a 1976 Chevrolet pickup truck , what is the compression ratio ? Will this engine run on 87 octane fuel ? I just picked one up.
by Petesnova on May 16th, 2007 | 2 answers | in Pre-1980 trucks and SUVs

What is the firing set up on a 1992 chevy 4x4, 6 cyl pickup truck
by ola_erdy on April 26th, 2007 | one answer | in Pre-1980 trucks and SUVs

What is the firing order of a 1979 chevy luv
by Anonymous on April 1st, 2007 | one answer | in Pre-1980 trucks and SUVs

Is timing my chev 350 to 14 deg. ret. odd? it runs great around there. has mild cam, 2.02 int. 1.50. exst.(82cc)heads, 65,000 volt hei dist., performer intake, edelbrock 600 carb.
by lwrdrchevs on February 15th, 2007 | 2 answers | in Pre-1980 trucks and SUVs

How do you remove the dash from a '66 chevy c10 pickup after you remove the 6 side bolts? is it seated under the windshield seal?
by lwrdrchevs on February 15th, 2007 | one answer | in Pre-1980 trucks and SUVs

What is the firing order for a 350 Chevy engine?
by emt20preacher on February 5th, 2007 | 5 answers | in Pre-1980 trucks and SUVs

I have a 63 chevy c-10 stepside taht has a 3 on the tree tranny. i want to transfer it to an floor shifter
by beginingmechanic on October 2nd, 2006 | 3 answers | in Pre-1980 trucks and SUVs

Where can I find the carb vacuum diagram for a 1977 Chevy El Camino V8 4bbl?
by oldguardduke on June 10th, 2006 | one answer | in Pre-1980 trucks and SUVs

Where is the timing mark set on a 1975 Chevy Luv Truck?
by CHASE RICE on March 9th, 2006 | no answers | in Pre-1980 trucks and SUVs

I am in the process of rebuilding the 350 engine on my 1979 Chevy 1/2 ton truck. Can anyone tell me where to find a free source online that gives online diagrams of components, seals, bearings, bushings, etc.?
by d aring on December 18th, 2005 | one answer | in Pre-1980 trucks and SUVs