- NEW!
Help answer this question below.
the power window/ 4wd-4lo blinking lights issue was fixed with one relay located to the right of the gas pedal, behind the stereo. There is a black case, take the cover off. it should have 7 relays<one bigger,square><7 smaller,rectangle> the one sqare is called two names by ford.
1. the power window relay
2. accessory relay
the autoparts stores will give you a replacement 'rectangle' if you ask for a power window relay. you have ask for, or remove, the accy. relay, to enter factory numbers to cross-reference.
plug in
does anyone have a wiring schematic or know the terminal destination for a 1998 Jimmy wiper motor ?
by comfrtzne on July 16th, 2010
| 1 person likes this
2004 mitsubishi galant battery cable how to replace and a picture or video of a cable and how to tighten
by questioncar on January 28th, 2011
| 1 person likes this
put car stereo in 04grand prixGTP, bare wire sparked, lost power door locks,AC, dash gauges, fuses in side pannel were fine, relay maybe?
by metroman1972 on July 11th, 2010
| 1 person likes this
how to replace a wheel stud on a 1994 honda passport 4x4
by wtf0303 on October 19th, 2010
| 1 person likes this
how long can i use my space saver wheel on my fiat? days months years?
by Dr.Rouge on December 24th, 2010
| 1 person likes this
You're reading My 1995 ford explorer power windows and door locks don't work. Also, the 4WD high & low lights blink. The 30 amp fuse that goes in the box under the hood that controls it, blows as soon as I try to put it in. Upon testing it's showin
Comments
I am not sure if this resolved the problem for the person who asked this question or not, but it sure helped me. I had three of my windows down and couldn't get them up. i found the black box, jiggled the relay and was able to get all three to roll up. I pulled the relay and will replace tommarrow. Thanks. You probably saved me a couple hundred dollars.
by Hopper on May 30th, 2009