- NEW!
Help answer this question below.
You need either a blower motor switch or blower motor resistor.
If you adjust the fan by turning a knob or moving a lever, then you need a switch
If you adjust fan speed by pushing a button, then you need a blower resistor.
Good luck.
Where is the Jeep Wrangler crankshaft position sensor?
by Answerbag Staff on August 17th, 2010
| 1 person likes this
Can you get full doors and half doors on a Jeep Wrangler and just switch them whenever you need?
by ryguy on January 24th, 2011
| 1 person likes this
Does the 2000 Wrangler have posi trac or limited slip differentials?
by Answerbag Staff on July 26th, 2010
| 1 person likes this
Where is the fuel pump located on a 1999 Jeep Wrangler?
by Answerbag Staff on July 19th, 2010
| 1 person likes this
just had my 88wrangler rebuit 4.2 L6 it will turn over but wont crank, any ideas?
by Cody_S8301 on February 21st, 2011
| 1 person likes this
You're reading I have a 2005 jeep wrangler SE. It only blows on the 4 setting and doesn't when the fan is on one, two or three. What's up?
Comments